Publicité
Les langues disponibles
Les langues disponibles
Problem
The milk does not froth. LatteGo is assembled
Milk is leaking from the
bottom of the LatteGo
milk container.
Cause
The AquaClean water filter is
clogged.
The grinder is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The pre-ground coffee
compartment is clogged
The machine circuit is blocked
by limescale.
incorrectly.
The milk container and/or
frame of LatteGo are dirty.
The type of milk used is not
suitable for frothing.
The frame and the milk
container are not assembled
properly.
Solution
Replace the AquaClean water filter
every 3 months. A filter that is older
than 3 months can become clogged.
Set the grinder to a coarser (higher)
setting. Note that this will impact the
coffee taste.
Remove the brew group and rinse it
under the tap (see 'Cleaning the brew
group under the tap').
Clean the coffee dispensing spout and
its holes with a pipe cleaner or needle.
Switch off the machine and remove
the brew group. Open the lid of the
pre-ground coffee compartment and
insert the spoon handle into it. Move
the handle up and down until the
clogged ground coffee falls down (Fig.
28).
Descale the machine with Philips
descaler. Always descale when the
machine prompts you.
Make sure that the milk container is
properly assembled to the frame of
LatteGo ('click') (see 'Assembling
LatteGo').
Disassemble LatteGo and rinse both
parts under the tap or clean them in
the dishwasher.
Different types of milk result in
different amounts of froth and
different froth qualities. We have
tested the following milk types which
proved to deliver a good milk froth
result: semi-skimmed or full-fat cow's
milk and lactose-free milk.
First insert the top of the milk
container under the hook at the top of
the frame. Then press home the
bottom part of the milk container. You
hear a click when it locks into place.
English
21
Publicité
