Publicité
Les langues disponibles
Les langues disponibles
6 Insert the filter vertically onto the filter connection in the water tank. Press it down to the lowest
possible point (Fig. 39).
7 Fill the water tank with fresh water and place it back into the machine.
8 If attached, remove the LatteGo.
9 Place a bowl under the hot water spout.
10 Press the start/stop
11 Hot water will be dispensed from the hot water spout during 1 minute.
12 The filter is now successfully activated.
Replacing the AquaClean water filter (5 min.)
After 95 liters of water have flowed through the filter, the filter will cease to work. The AquaClean
status indicator drops to 0% to remind you to replace the filter. As long as the AquaClean status
indicator is shown on the display, you can replace the filter without having to descale the machine
first. If you do not replace the AquaClean water filter in time, the AquaClean indicator goes out
after some time. In that case you can still replace the filter but you first need to descale the
machine.
When the AquaClean status indicator drops to 0% or when the machine reminds you to replace
the AquaClean filter:
1 take out the old AquaClean water filter.
2 install a new filter and activate it as described in chapter 'Activating the AquaClean water filter
(5 min.)'.
Replace the AquaClean water filter at least every 3 months, even if the machine does not yet
indicate that replacement is required.
Descaling procedure (30 min.)
Please use Philips descaler only. Under no circumstances should you use a descaler based on sulfuric
acid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water circuit in your
machine and not dissolve the limescale properly. Not using the Philips descaler will void your
warranty. Failure to descale the appliance will also void your warranty. You can buy Philips
descaling solution in the online shop at www.philips.com/coffee-care.
When the machine needs descaling, a message appears on the display.
1 Touch the clean
2 Follow the instructions on the screen.
3 If attached, remove LatteGo.
4 Remove the drip tray and the coffee grounds container, empty them and put them back into
place.
5 Remove the water tank and empty it. Then remove the AquaClean water filter.
6 Pour the whole bottle of Philips descaler in the water tank and then fill it with water up to the
Calc / Clean indication (Fig. 40). Then place it back into the machine.
7 Place a large container (1.5 l) under the coffee dispensing spout and the water spout.
8 Press the start/stop
approximately 30 minutes and consists of a descaling cycle and a rinsing cycle.
button to start the activation process.
icon on the user interface and select 'Descaling' in the menu.
button to start the descaling procedure. The descaling procedure lasts
English
15
Publicité
