Publicité
Les langues disponibles
Les langues disponibles
VI. INSTALLATION:
1. Remove factory plastic rear a-arm guards by
removing two screws on each guard.
2. Install guard (A1) and fasten using #12 screws (B3)
through rear mounting holes of guard. Do not
tighten. (Figure 1)
3. Place bracket (A3) on top of lower a-arm.
4. Install bottom inner bolt and nut (B2 & B1). Do not
tighten. (Figure 2)
5. Fasten through lower mounting holes of guard (A1)
to bracket (A3) using 5/16" bolts (B2) and 5/16" nuts
(B1). Do not tighten. (Figure 2)
6. Tighten all fasteners to torque specifications listed
above. Tighten #12 screws (B3) first, then 5/16"
bolts and nuts (B2 and B1).
7. Repeat steps 1 through 4 for guard and bracket (A2
& A3) on other side.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Inner Bolt
Last fasteners to
install
PAGE 4
Figure 1
Figure 2
Bracket
Figure 3
74645A0
Publicité
