Midland ALAN 42 MULTI Mode D'emploi page 13

To activate this function, operate as follows:
- Select the desired channel through the channel selector
- Press the DW button
- Select the second channel
- Press the button DW again
To cancel the function press again the DW button or the PTT button.
-
16. SCAN button: with this control, you can automatically seek for a busy channel.
• Turn the Squelch clockwise until the background noise is no longer heard.
• Press the ''SCAN'' button: the transceiver will scan automatically all the
channels until a carrier is being received.
• When it finds the carrier, it stops and starts again some seconds after the end
of the communication on the channel.
• When the radio is transmitting, the scan function is deactivated.
17. ✩ button: display lighting (temporized).This function allows to operate in darkness
conditions. By pressing this button, the display is lighted for 5 seconds.
18. Push to talk button (PTT): Its pressure activates the transmission. When
released, the receiver is activated.
19. Battery compartment: insert 6 Ni-Cd alkaline batteries.
C H
A N
N E
L
20. Hole for wrist belt
21. Channel UP: to skip to the next channel. Keeping this button pressed, the
"autorepeat" function is obtained.
22. Channel DOWN: to skip to the previous channel. Keeping this button pressed, the
"autorepeat" function is obtained.
23. Battery pack contact: lift the button and take the batteries out (see drawing).
24. Auxiliary antenna contact: for the connection to the vehicular adaptor.
24
4 4
it is