Ryobi R18RS Traduction Des Instructions Originales page 4

OPERATION TIPS
WARNING
Be careful not to twist or bend the saw blade.
■
Do not force the product.
■
Use cutting oil when cutting soft metals and steel.
Cutting oil also keeps the blades cool, increases cutting
action, and prolongs blade life.
■
Clamp the workpiece firmly and cut close to the
clamping point to eliminate any vibration of the work.
When cutting conduit pipe or angle iron, secure the
workpiece with a vise, if possible, and cut close to the
vise. To cut a thin-sheet material, place the material
between two hardboards or plywood and clamp the
layers to eliminate vibration and material tearing.
■
Always keep a firm forward pressure on the tool to keep
the shoe in contact with the workpiece.
■
Do not use cracked or distorted saw blades. Do not use
saw blades that are damaged or deformed.
WARNING
Dust from certain paints, coatings, and materials may
cause irritation or allergic reactions. Dust from wood
such as oak, beech, MDF, and others are carcinogenic.
Materials containing asbestos should only be worked on
or processed by qualifi ed specialist operators.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating the product. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
MAINTENANCE
WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
■
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt and carbon dust.
■
Do not, at any time, let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
■
Always wear safety goggles or safety glasses with side
2 | English
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
■
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Electrical tools used on fi berglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fi berglass
chips and grindings are highly abrasive to bearings,
brushes, and commutators. We do not recommend using
the product for extended periods of time on these types
of materials.
WARNING
Do not use compressed air to blow dust from the product.
This practice is dangerous and can cause dirt and grit to
be blasted into someone's eyes, causing injury.
LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety Alert
No-load speed
V Volts
Direct current
min -1 Revolutions or reciprocations per minute
CE Conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Please read the instructions carefully before
starting the product.