Publicité
Les langues disponibles
Les langues disponibles
GB
ASSEMBLY INSTRUCTIONS
Only use the included waterproof boundary wire connectors (17) to join together two
pieces of boundary wire.
See below for some further sketches giving more distance guidelines.
Connector
F, black
Avoid right angles when running the boundary wire around a corner. Instead, separate into
two 45° angles.
In case the included boundary wire is too short for your garden, more is available from our
service team.
The wire's total length must not exceed 300 m.
Suitable location for
the docking station
Connector B, red
1 m extra wire
for potential
adjustment
NO
OK
38
ASSEMBLY INSTRUCTIONS
Prepare the boundary wire for the docking station
Use a wire stripper to remove 10-15 mm insulation from each end. Twist the threads
tight.
Connect the docking station to the boundary wire
Place the docking station on the end of the boundary wire so that the wire runs lengthwise below
the middle of the docking station. Connect that end to the left (black) connector marked "F"
(front). Connect the other end to the right (red) connector marked "B" (back).
F (black)
IMPORTANT INFORMATION
Double check that the charger connections are as shown below. Even if there is a blue light, if
the connectors are wrongly connected the machine will not work.
10 - 15 mm
B (red)
39
GB
Publicité
