Yard force SA650ECO Mode D'emploi page 28

GB
TROUBLESHOOTING
Nr. Message Symptom
The Robotic Mower
does not receive the
6 boundary wire signal.
LED flash
(Robotic Mower placed
inside boundary area.)
Battery voltage is
7 too low to perform
LED flash
normal mowing.
8 Charging
LED flash
9 Reset factory defaults
Action
1. Verify that the docking station indicator light
is blue. If not, refer to installation instructions
and docking station troubleshooting.
2. Verify that both docking station and Robotic
Mower are set to the same signal, S1 or S2.
3. Check if the boundary wire is connected in
the correct direction.
4. Disconnect the boundary wire from the
docking station, and reconnect it the
opposite way.
1. Normally if voltage is low, the mower should
automatically return to the docking station.
2. If not, please carry your mower manually to
docking station when it has stopped on the
lawn.
Wait for battery to recharge.
1. Switch OFF the device.
2. Place Robotic Mower on flat, even surface.
3. While pressing and holding the START
button, switch ON the device.
4. The Robotic Mower will boot up. All LEDs
flash.
5. Release START button. Factory reset is
complete.
Note: The Robotic Mower must stand on a flat
surface, because the inclination sensors are
also zeroed.
54
DECLARATION OF CONFORMITY
Declaration of Conformity
MEROTEC GmbH
Otto-Brenner-Str. 8
47877 Willich, Germany
Declare that the product:
Description: 28V Robotic Mower
Model No. SA650ECO
Function: Cutting grass
Conforms to the following directives and standards
Machinery Directive 2006/42/EC
EN 60335-1:2012+A11+A13+A1+A14+A2, EN 50636-2-107:2015+A1
+A2, EN 62233:2008
EN 55014-1:2017
EN 55014-2:2015
EN 301 489-1 V2.2.3
EN 301 489-3 V2.1.1
Draft EN 303 447 V1.2.0
EN62311:2008
RoHS Directive 2011/65/EU
WEEE Directive (2012/19/EU)
Authorized Signatory
Signature:_____________
Place: Willich
Name: Roland Menken
General Manager
Date: 2020-09-18
MEROTEC GmbH
Otto-Brenner-Str. 8
47877 Willich, Germany
We
55
GB