Télécharger Imprimer la page

Yard force SA650ECO Mode D'emploi page 17

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 60
GB
ASSEMBLY INSTRUCTIONS
Flowerbeds
Use the boundary wire to exclude any flowerbeds from the cutting area. There are two options
for the two lengths of boundary wire running between the flowerbed and the
outer boundary:
1) Keep the distance between the parallel wires above 10 cm. This way, the Robotic Mower
will recognise the boundary wire as an ordinary obstacle. When cutting, it will "bounce" off
it as usual. When following the boundary wire back to the docking station, it will take the
detour around the flower bed.
2) Alternatively, keep the distance between the two parallel wires below 5 mm. Do not cross
the wires - see below. This way, the Robotic Mower will not recognise the wires and travel
across them unhindered. This option requires placing an obstacle on the boundary wire
around the flowerbed. Place the obstacle, for example a large rock or pole, near position A
indicated on the below illustration. The obstacle must be surrounded by a flat area of about
1 m x 1 m, without any slopes. This obstacle will allow the machine to exit the circle.
> 10 cm
< 5 mm
32
ASSEMBLY INSTRUCTIONS
Ponds and Pools
While the Robotic Mower is protected against rain and spray water, being submerged is likely
to cause severe damage to the electronic parts.
Therefore, it is imperative to exclude any pools from the cutting area. For added safety, we
recommend placing a fence around the pool.
General Dos and Don'ts
Do not run the boundary wire directly above an ordinary power cable.
The power cable's electric field may distort the boundary signal.
Never cross two boundary wires! This will distort the radio signal and cause erratic behavior
of the Robotic Mower.
Never cross the wires!
If you have created a boundary corridor inside your working area, the corridor should be at
least 2 m wide and a max length of 8 m.
If a corridor is too narrow or too long, the Robotic Mower might not be able to navigate it
from one end to the other.
Max length
of the
corridor is
8 m
Minimum width of
the corridor is 2 m
> 10 cm
33
GB

Publicité

loading