Tripp-Lite OMNIVS800LCD Manuel D'utilisation page 7

Basic Operation
Battery Power Mode LCD Data
The LCD touchscreen offers 5 screens of UPS and site power information when the UPS
is operating in battery power mode. Screens 1-4 (Output Voltage, Input Voltage, Load %,
Battery Charge Level) are available for viewing in battery power mode. Press the front panel
LCD to advance to the next screen. Screen #5 (Overload) is displayed automatically only
when the BATTERY/SURGE PROTECTED outlets are loaded to levels greater than 100%.
1
4
1
Output Voltage
2
Input Voltage
Note: The LCD touchscreen will remain ON continuously during battery mode operation.
Critical Fault Screens
Error Code Critical Fault
F01 OUTPUT SHORT
F02 OVER LOAD
F03 OVER CHARGE
F04 BATTERY LOW
VOLTAGE
F05 BATTERY MODE
HIGH OUTPUT
21-10-017-9338D9-Book.indb 7 21-10-017-9338D9-Book.indb 7
2
5
3
Load %
4
Battery Charge Level
Solution
Disconnect load(s) from UPS outlets. Power off UPS and
contact Tripp Lite Technical Support for assistance.
Remove excess load, check load meter on LCD for load
status.
Turn unit off, unplug UPS and contact Tripp Lite
Technical Support for assistance.
Charge UPS for 24 hours. If problem persists, replace
battery and contact Tripp Lite Technical Support if
problem persists.
Turn off power to the UPS and contact Tripp Lite
Technical Support for assistance.
7
3
5
Overload
10/15/2021 2:45:54 PM 10/15/2021 2:45:54 PM