Publicité
Les langues disponibles
Les langues disponibles
6. CONNECTION TO THE MAINS
1.
Ensure that mains voltage and frequency are the same as those stated on the rating plate
2.
to the appliance.
Ensure that the supply socket has the following characteristics:
earthed. b) It is appropriate for the nominal current as set out on the rating plate. c) It complies with the
IEC regulations: - magnetothermic differential switch (circuit breaker) with In = nominal value as stated on
the rating plate; - Differential switch with sensitivity Id = 30 mA. . Ensure that there is no danger of
explosion (AD) in the room.
use.
5.
Insert the plug. (do not use triple and reduction outlets).
or storage, been erroneously placed in horizontal position or upside-down, it should be left in the correct
vertical position for at least 3 hours before connecting it to the electrical supply. (See picture 4)
7. CONTROL
The appliance is supplied with adjusting controls situated on the front side.
temperature in the appliance
switch on the light inside the appliance.
4 "SET or P"
Press button
6 "DOWN"
button
(See picture 5)
8. CHECKING THE CORRECT FUNCTIONING
CHECK THAT: 1.
Plug connected. . Refrigeration switch is switched on with the green light lit up.
3.
Thermometer shows the temperature suitable for the goods to be stored. . Inside lights switched on.
5
. Door completely closed.
7
lamps. . The ambient temperature does not exceed that in which the appliance is designed to work
normally, i.e. +30°C 55% r.h. (climatic class 4). . Make sure that a suitable air flow can reach the motor,
keeping the appliance at least 10 cm from the wall. . Make sure that the appliance is correctly loaded,
taking into consideration the capacity of the shelves.
9. REPLACING THE MAGNETIC STRIP ON THE DOOR
1
. Open the door
. 2
. Take the strip with both hands and slide it out of its fixing position on the door runner
3
profile. . Replace with a new strip, making sure to press the strip down along the edges. (See picture 6)
Our products are for internal use only – do not install outside
restaurants, shops.
Operator's guide
4.
The connecting cable to the appliance is H05 VVF, designed for internal
. Thermostat:
to adjust the temperature in the appliance.
3. Refrigeration switch:
to see temperature setting, this can be altered by using button
2
6.
Appliance not exposed to the direct light of the sun or to high powered
8
9
7
a) It is properly
3
N.B.
If the appliance has, during transport
1. Thermometer
2. Light switch:
to switch on the refrigeration unit. a)
4
(A)
attached
I
UK
D
E
F
: to read the
NL
to
P
5 "UP"
or
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
Publicité
