Hach IO9000 Instructions D'utilisation page 6

4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
3.3 Product overview
The I/O module connects to an AS950 sampler or an FL1500 flow logger to add relay, analog input,
analog output and digital output terminals.
Note: Use the IO9004 module with the FL1500 flow logger.
3.4 Product components
Make sure that all components have been received. Refer to
damaged, contact the manufacturer or a sales representative immediately.
Figure 1 Product components
1 I/O module
2 Mounting brackets
3 Self-drilling screws
Section 4 Installation
This instrument is rated for an altitude of 2000 m (6562 ft) maximum. Although the use of this
equipment above the 2000 m altitude does not show any substantial safety concern, the
manufacturer recommends that users with concerns contact technical support.
4.1 Install the brackets
Install the brackets as shown in the illustrated steps that follow.
2
The bare-wire option is an alternative to the cable connector.
6 English
Figure 1. If any items are missing or
4 Screws for mounting brackets
5 Bare-wire connection (optional)
6 Cable connector
2