HTW -AT-V100MR290A Manuel De L'utilisateur Et D'installation page 80

OPERATION THE UNIT
User interface and operation
1) power 'ON'
When turning 'ON' the power, whole icons are displayed on the controller screen for
3 seconds. After checking that everything is correct, the unit enters into the standby mode.
2) button
Press this button and keep for 2 seconds when the unit is standby, the unit can be turned
'ON'. Press this button and keep for 2 seconds when the unit is running, the unit can be
turned 'OFF'. Short press this button to entry or exit the parameter setting or checking.
and
3) buttons
1. These are the multi-purpose buttons. They are used for the temp setting, parameter setting,
parameter checking, clock adjustment and adjustment of the timer.
2．During running status, press
3．Press these buttons when the unit is on clock setting status, the hour(s) and the minute(s)
of the clock time can be adjusted.
or button to adjust the setting temperature directly.
26