HTW -AT-V100MR290A Manuel De L'utilisateur Et D'installation page 61

Multiple Functions
The special design of the air inlet and outlet makes the unit suitable for various ways of connections. With
different ways of installation, the unit can work as just a heat pump but also as a fresh air blower, a
dehumidifier, or an energy recovery device.
Other features
Stainless steel tank and a magnesium stick assure the durability of components and the tank.
High-efficient R290 specialized compressor.
Electrical element is available in the unit as a back-up, assuring constant hot water even in extreme
cold winters.
SAFETY INSTRUCTIONS
To prevent injury to the user, other people, or property damage, the following instructions must be
followed. Incorrect operation due to ignoring of instructions may cause harm or damage.
Install the unit only when it complies with local regulations, by-laws and standards. Check the main
voltage and frequency. This unit is only suitable for earthed sockets, connection voltage 220 – 240 V
~ / 50Hz.
The following safety precautions should always be taken into account:
-
Be sure to read the following WARNING before installing the unit.
- Be sure to observe the cautions specified here as they include important items related to safety.
- After reading these instructions, be sure to keep it in a handy place for future reference.
Warning
Do not install the unit yourself.
Incorrect installation could cause injury due to fire, electric shock, the unit falling or leakage of water.
Consult the dealer from whom you purchased the unit or a specialized installer.
Install the unit securely in palace.
When insufficiently installed, the unit could fall causing injury. The bearing surface should be flat to
bear the weight of the unit and suitable for installing the unit without increasing noise or vibration.
When installing the unit in a small room, please take measures (like sufficient ventilation) to prevent
the asphyxia caused by the leakage of refrigerant.
Use the specified electrical wires and attach the wires firmly to the terminal board
(connection in such a way that the stress of the wires is not applied to the sections).
Incorrect connection and fixing could cause a fire.
7