Husqvarna 435e Manuel D'utilisation page 42

Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw
Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Bar and chain combinations
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
Saw chain filing and file gauges
42 – English
TECHNICAL DATA
Bar
Thickness of drive
links, inch/mm
1,3
Max. nose radius Type
10T
10T
Husqvarna H30
10T
10T
Chain
Drive link count
56
64
66
72
115 13 80-32 Rev.3 2008-12-17