Qlima S 2326 Manuel D'utilisation page 158

To operate your unit manually:
1. Open the front panel of the indoor unit.
2. Locate the MANUAL CONTROL button on the right-hand side of the unit.
3. Press the MANUAL CONTROL button one time to activate FORCED AUTO mode.
4. Press the MANUAL CONTROL button again to activate FORCED COOLING mode.
5. Press the MANUAL CONTROL button a third time to turn the unit off.
6. Close the front panel.
Range
NOTE: Do not move louver by hand. This will cause the louver to become out of sync. lf this occurs, turn off
the unit and unplug it for a few seconds, then restart the unit. This will reset the louver.
CAUTION
Do not put your fingers in or near the blower and suction side of the unit. The high-speed fan
inside the unit may cause injury.
Deflector
rod
C
CARE AND MAINTENANCE
Cleaning Your Indoor Unit
BEFORE CLEANING OR MAINTENANCE
ALWAYS TURN OFF YOUR AIR CONDITIONER SYSTEM AND DISCONNECT ITS POWER SUPPLY
BEFORE CLEANING OR MAINTENANCE.
4
158
man_S60xx EU ('24) TD.indd 158 man_S60xx EU ('24) TD.indd 158
Fig. A
Manual control button
Fig. B
22-01-2024 11:56 22-01-2024 11:56