Original Prusa XL Mode D'emploi page 28

ÉTAPE 5 Installing the ToolChanger
Be careful that the springs and pins do not fall out when handling the parts.
Line up the screws in the TC block lower assembly lock with the blind holes in the
X-carriage. See the correct orientation of the part. Use the U-shaped groove in the
part.
Take a look at the X-carriage from the rear side.
Attach the TC block lower assembly lock to the X-carriage and secure it with two
M3x12bT screws from the front side. Ensure the correct orientation of the part.
Attach the TC block upper assembly to the X-carriage from the top and secure it
with two M3x12bT screws from the front side.
ÉTAPE 6 Covering the X-carriage
28 Mise à niveau de l'Original Prusa XL Mono-outil vers Cinq têtes
4. ToolChanger assembly
Attach the x-carriage-cover on the
X-carriage with the hole up.
Push the center of the cover using
your thumb. The cover will then
snap into the latches on the X-
carriage. You will feel a light "click"
when it is successfully snapping.