Original Prusa XL Mode D'emploi page 21

ÉTAPE 3 PTFE unpluging
ÉTAPE 4 Disconnecting the Nextruder cable
Turn the printer, so the back side of the printer is facing you.
There is an antenna cable behind the antenna-holder, do not pull the connector!
Loosen two screws on the cover slightly. No need to remove them completely. Push
the cover to the right and gently remove it from the screws.
Push the safety latch and disconnect the Nextruder cable from the connector
"DWARF1".
Attach the antenna-holder to the screws and push the cover to the left. Tighten the
screws.
Mise à niveau de l'Original Prusa XL Mono-outil vers Cinq têtes
3. Detaching the Nextruder
Turn the printer so the left side of
the printer is facing you.
Gently push the black collet to
release the PTFE tube.
Pull out the PTFE tube.
21