Original Prusa XL Mode D'emploi page 26

ÉTAPE 1 Tools necessary for this chapter
ÉTAPE 2 Preparing the X-carriage
Reminder: To handle the printer, always grab the handles on both sides of the
printer. Do not lift the printer by the aluminum extrusions or the metal sheet
profiles on top.
In the following steps, we will work with tools and install the Nextruder above the
heatbed, it is recommended to protect it against any possible damage. An empty
Prusament box can serve this purpouse.
Check the empty cardboard box approximately to the front center part of the
heatbed.
Move the X-axis assembly all the way to the front side of the printer.
Move the X-carriage approximately to the center of the X-axis.
26 Mise à niveau de l'Original Prusa XL Mono-outil vers Cinq têtes
4. ToolChanger assembly
For this chapter, please prepare:
T10 Torx key (T10 Torx screwdriver)