Gloria PRO 1200 LI-ON Mode D'emploi page 33

4 Technical data
BATTERY KNAPSACK SPRAYER PRO 1200 LI-ON
Item number:
(battery and charger not included)
Battery (NOT included in item 000067.0000)
Type:
Nominal voltage:
Rating:
Charging station (AL 1810 CV) (NOT included in item 000067.0000)
Input:
Output:
Battery charging time (100%):
Per. charging temp. range:
Protection class:
(These following rights apply to the AL 1810 CV charger)
BATTERY KNAPSACK SPRAYER
Max. filling capacity:
Permissible operating pressure:
Empty weight:
Weight filled:
Hollow cone nozzle, spraying angle; material ø 1mm; 55°; Brass
Flat spray nozzle, spraying angle; material
Container material:
Material seal:
Pump:
Mesh size of filter in
quick closure valve:
Mesh size of filling strainer:
Filter in the appliance:
5 Assembly
1
Figure
NOTE!
Your device is delivered fully assembled
except for the installation of the spraying
lance.
1
Remove the BATTERY KNAPSACK
SPRAYER from the packaging and
screw the spraying lance (K) onto the
quick closure valve (H). If required,
mount the spraying lance extension
(accessories) incl. clip (J) as well.
000067.0000
Lithium-ion (Bosch PBA 18.0 V 2.5 Ah)
18.0 V
2.5 Ah
220-240 V~ / 50/60 Hz
14.4-18.0 V / DC / 1.0 A
244 Min.
0 – + 45 °C
II
12 L
+ 40°C]
3.74 kg
15.74 kg
80°; Brass
Polyethylene
FKM
Polyethylene / TPV
0.9 mm
1.5 mm
1.2 mm
6 Prior to initial commissioning
WARNING
BEFORE USE OBSERVE CHAPTER 2
"FOR YOUR SAFETY". You should
therefore observe the following
safety instructions:

The mains voltage must be in
compliance with the voltage spec-
ification (V~) on the type plate of
the charger.
Operate charger only in
dry rooms.
33