Page 3 of 8
•
Remove the original RHS pillion footrest from the bike. To do this, first remove the OEM nut
from the back of the original exhaust using a spanner and Allen key to hold the bolt.
•
Remove the OEM bolt to disconnect from the hanger. Ensure the exhaust does not drop or
change position during throughout this fitting process.
•
Remove the 2 upper bolts connecting the pillion foot peg hanger to the bike and remove
carefully.
•
Place one M8 washer (ITEM 2) over each of the shorter 20mm bolts (ITEM 3).
•
Thread these bolts into the upper holes of the R&G Exhaust hanger (HB0099 – ITEM 1) as
shown in the assembly diagram.
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
ASSEMBLY DIAGRAM
FITTING INSTRUCTIONS
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301
1
R&G
www.rg-racing.com
EH0099
Email:
info@rg-racing.com