Publicité
Les langues disponibles
Les langues disponibles
10.3 BLOWER REPLACEMENT
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
This appliance comes equipped with a blower, a heat sensor, variable on/off speed control and a power cord.
The blower is thermally activated, so when
it is turned on, it will automatically start
approximately 15 minutes after lighting the
appliance and will run for approximately
30 minutes after the appliance has been
turned off. Use of the fan increases
the output of heat. Air, drawn in through the lower louvre access door, is driven up the back of the fi rebox, and
exhausted as hot air between the upper louvres.
Open the lower control area.
A.
Remove the control panel (3 screws).
B.
Unplug the blower from the junction box or turn
C.
off the power to the appliance if hard wired.
Undo the fastener at the left side of the blower
D.
mounting plate. The blower should now slide to
the left, away from the mounting tab.
Finally, disconnect the slip-on connectors at the
E.
motor of the blower.
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from
this condition is not covered by the warranty policy.
WARNING
!
RISK OF FIRE AND ELECTRICAL SHOCK.
VOID THE WARRANTY AND CERTIFICATION.
CORD BENEATH THE APPLIANCE.
CONTACT WITH MOVING OR HOT OBJECTS.
G
B
W
VARIABLE SPEED SWITCH
BLOWER REPLACEMENT
B
A
51
51.5
HEAT SENSOR
FAN
C
W415-1519 / C / 11.06.15
EN
Publicité
