Napoleon GX70NT Instructions D'installation Et D'opération page 38

38
EN
Place the end of log #5 on the left end of
E.
log #1 and on the pin of log #2.
6.5 GLOWING EMBERS
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fi bre hairs will glow. The ember material will only glow when exposed to direct fl ame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER
from your authorized dealer / distributor.
6.6 LOGO PLACEMENT
Remove the backing of the logo supplied and place on the glass viewing door,
as indicated.
W415-1519 / C / 11.06.15
5
4
Place log #6 along the back edge of the grate
E.
wrapping around the 3rd grate post. Ensure
logs do not cover any ports.
6
TM
TM logs available
½"
(12.7mm)
LOGO
½"
(12.7mm)
97.1A