Publicité
Les langues disponibles
Les langues disponibles
32
5.3
RECESSED INSTALLATION
EN
INSTALLING A TELEVISION ABOVE A FIREPLACE MAY CAUSE DISCOLOURATION, MELT OR DAMAGE
THE ELECTRONIC DEVICE. USE THE INDICATED CLEARANCE AND REFER TO THE INSTRUCTIONS OF
WARNING:
Non-combustible facing materials must not project more than 4" (102mm) from
the face of the door (all three sides). If greater projections are desired, increase the clearance to
the sides and top by 2" (51mm) for every addtional 1" (25mm) of projection. If using an optional
surround, the same rule applies, starting from the top of the surround. Ensure clearances are
maintained for surround removal, as it must lift off the appliance for maintenance.
Before placing anything above a heat source, it is advisable to follow proper clearances and
manufacturer's instructions.
Installing a mantel between a heat source will reduce the affect of direct heat on electronics or other
A.
materials placed above a mantel. Follow mantel height and depth instructions for proper clearances.
NOTE: Increasing the horizontal length of the mantel will further reduce the intenstiy of heat.
Refer to "MINIMUM MANTEL CLEARANCES" section for more detailed mantel clearance information
B.
W415-1519 / C / 11.06.15
WARNING
!
YOUR MANUFACTURER FOR FURTHER INFORMATION .
A
B
MINIMUM CLEARANCES CHART
A
B
C
4.5" (114mm) MAX
7.50" (190mm) MIN
42.625" (1083mm) MIN
NON-COMBUSTIBLE
MATERIAL
C
Publicité
