Publicité
Les langues disponibles
Les langues disponibles
6.4
LOG PLACEMENT
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
Log colours may vary. During initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
Blocked burner ports can cause an incorrect fl ame pattern.
Place the rear log #1 onto the locating
A.
studs along the back edge of the
PHAZERAMIC
TM
right side of the log.
Install pin in the front right hole located in
C.
the burner. Place log #3 on the pin resting
it along the edge of the burner against the
brick panel. Make sure not to cover any
ports.
!
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
PIN
1
burner. Install pin in the
PIN
3
WARNING
PIN
Position log #2 onto the locators on the
B.
PHAZERAMIC
right and left sides of the log.
Place log #4 onto the right side pin in log
D.
#2 and the pin in log #1
76.1A
2
burner. Install pins in the
TM
4
W415-1519 / C / 11.06.15
37
EN
Publicité
