Makita BMR102 Manuel D'instructions page 9

LCD Display:
A. Radio alarm
B. HWS buzzer alarm
C. Scan tuning
D. Band Indicator
E. Low battery indicator
F. Preset stations
G. Sleep and Snooze status
H. Frequency
I. Stereo symbol and Volume
J. Clock
K. Time set
L. PM for clock
The following tables indicate the operating time on a single charge.
7.2 V 9.6 V
BL7010
PA09
9050
9100
9120
9100A
9102
9122
9102A
BH9020
BH9020A
9134
9135
BH9033
BH9033A
: Cluster Battery
: Slide Battery
WARNING:
Do not use two main batteries at the same time.
3-1. Installing or removing Slide battery cartridge (Fig. 4)
• To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click.
• If you can see the red indicator on the upper side of the
button, it is not locked completely. Install it fully until the
red indicator cannot be seen. If not, it may accidentally
Battery Cartridge Voltage
10.8 V 12 V
PA12
1250
1200
BL1013 1220
1200A
1202
1222
1202A
BH1220
BH1200C
1234
1235
1235F
BH1233
BH1233C
Battery Installation
Note:
Keeping back up batteries inside the compartment
prevent stored data in preset memories from being lost.
1. Pull out the battery compartment locker to release
battery compartment. There are main battery pack
compartment and back up battery compartment.
(Fig. 2 & 3)
2. Remove back up battery compartment cover and
insert 2 fresh UM-3 (AA sizes). Make sure the
batteries are with correct polarity as shown inside the
compartment. Replace the battery cover.
3. After back up batteries are inserted, insert the main
battery pack to power radio. The suitable battery
packs for this radio listed as the following table.
14.4 V 18 V
PA14 PA18
1450 1850
1420 BL1815
BL1415
1422 1822
BH1420
1434 1834
BH1427
1435 1835
1435F BL1830
BL1430
BH1433
fall out of the tool, causing injury to you or someone
around you.
• Do not use force when installing the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
• To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge or
pressing the buttons on both sides of the cartridge.
WARNING:
Do not use two main batteries at the same time.
AT SPEAKER OUTPUT=
50 mW + 50 mW
unit: Hour
Approx. 7.0
Approx. 8.0
Approx. 12.5
Approx. 16.5
Approx. 17.0
Approx. 19.0
Approx. 21.0
9