Publicité
Les langues disponibles
Les langues disponibles
3.7
Armrest Width and Fore-Aft Position Adjustment
The Revive Bari armrests can be positioned front-to-
back and side-to-side. This enables the effective seat
width to be increased or decreased to accommodate wide
occupants while facilitating passage through standard
Armrest Width and Fore-Aft Position
size doorways and also allows for comfortable leg
positioning while voiding.
3
Three indexed armrest positions are provided.
To Move the Armrest from one Position to Another:
- Loosen both front and rear hand wheels.
2
- Depress both front and rear detent pins simultaneously.
- While depressing the pins, move the upper armrest
assembly in a rotating motion to the desired position.
2
1
- Once both detent pins engage, re-tighten both front and
1
rear hand wheels. The armrests may also be positioned
in any non-indexed position, by moving the armrest to
Wide-Middle Position
the desired non-indexed position and tightening the
Hand Wheels
CAUTION: Always ensure that both hand wheels are
tightened prior to using or loading the armrest with the
occupant. If the hand wheels are not tightened, any
transverse load applied to the armrest will be carried by
the detent pins, which will become crushed and will
render them useless.
When depressing the detent pins, ensure that they are
depressed fully into the tube. Even prior to moving the
armrest, ensure that the detent pins are not encountering
any resistance which could prevent them from recessing
by removing any vertical and fore-aft horizontal loads.
This load-free state can be confirmed by loosely moving
the armrest fore and aft prior to swiveling the armrest. If
the detent pins are even slightly raised above the surface
of the tube, they will prevent the armrest from moving
freely. This is the most common reason for the armrests
malfunctioning.
13
Publicité
