Oase BioTec ScreenMatic 2 18000 Notice D'emploi page 22

Connecting a UVC clarifier
Fitting the outlet
Prerequisite:
• The container is open. (→ Remove the container cover)
• The screen holder is hinged up. (→ Hinging the screen holder up/down)
How to proceed:
1. Fit the UVC clarifier with flat seal into the inlet opening.
2. Screw the distributor nut with O ring onto the stepped hose adapter and hand tighten.
– Read the UVC clarifier operating instructions.
Outlets
• Use suitable pipes.
• Do not use any right-angled bends. Bends with a maximum angle of 45° are very efficient.
• Standing water in pipes can freeze when there is severe frost and cause pipes to burst. For this
reason, lay the pipes and hoses with a gradient (50 mm/m) to ensure that they can run empty.
• Pipe dimensions: (→ Unit data)

Support the connected pipes. This increases the stability of pipe constructions and pre-
vents them from sagging.
22
BTC0104