Pfannenberg PWS 6502 T Serie Manuel D'utilisation page 44

GB
Mounting PWS air/ water heat exchanger (Side mounting)
Switch cabinet assembly
Requirements
- Cut-out for PWS air/water heat exchanger is created, see figure
(Side mounting).
- Air/water heat exchanger has been de-energized.
Required tools and material
- Installation tool
- Accessory kit: Threaded bolts, screws, nuts, washers
Procedure
▪ Screw the two threaded bolts provided (accessory pack) into the fastening points (1) of the air/ water heat
exchanger.
▪ Suspend the unit on the switch cabinet with the threaded bolts (1) installed from outside.
▪ Screw unit tightly to the inside of the switch cabinet.
 Use the supplied screws, nuts and washers (accessory kit) to fasten the unit.
▪ Tighten fastening.

The air/ water heat exchanger is attached to the switch cabinet and ready for electrical connection,
see Electrical connection.
Operating manual PWS and PWI 6502 T 785408480 © Pfannenberg GmbH
Mounting 7 - PWS air/ water heat exchanger (Side mounting)
Assembly of PWS air/ water heat exchanger
Page 13 / 31