Pfannenberg PWS 6502 T Serie Manuel D'utilisation page 40

GB
3 Assembly and initial commissioning
3.1 Transport
WARNING
Danger due to uncontrolled movements
Improper securing of the unit can result in severe accidents.
➢ Loading must only be carried out by trained, qualified personnel.
➢ Lash the unit correctly for transport on a truck or trailer.
➢ Only use lashing straps with an adequate rated strength.
➢ Use slip-resistant materials for securing, e.g. anti-slip mats.
➢ When loading by crane, do not walk or stand under the raised units.
NOTE
Danger of material damage during transport and setting down of the units.
➢ Improper unit securing or uncontrolled movements can cause damage.
➢ Exercise maximum caution during movement and transport of the units.
➢ Always transport the unit in the position of use.
 Transport of the air/water heat exchangers must always take place with the packaging provided at the factory. It
comprises an outer carton, bottom plate and base and top cushions.
Transporting air/ water heat exchanger
Requirements
- Air/water heat exchangers are in the packaging provided by the factory.
Required tools and material
- Lashing straps, loading crane, if applicable
Procedure
▪ Secure properly for transport with lashing straps. Always transport in the position of use.
▪ Only hoist air/water heat exchangers on the housing.
▪ Always raise air/water heat exchangers slowly and evenly and set down safely.

Air/water heat exchanger was properly transported and loaded.
3.2 Storage
•
Do not expose air/water heat exchangers to temperatures higher than +70 °C in storage.
•
Always store air/water heat exchangers in the position of use.
 The warranty will no longer apply if these instructions are not observed.
Operating manual PWS and PWI 6502 T 785408480 © Pfannenberg GmbH Page 9 / 31