Pfannenberg PWS 6502 T Serie Manuel D'utilisation page 43

GB
3.4.2 Assembly of PWS air/ water heat exchanger (Side mounting)
Figure 5 - Switch cabinet exterior view
Holes for PWS air/water heat exchangers
Pos Designation
1 Holes
3 Dimensions in mm
Attaching cut-out for PWS air/water heat exchangers
Requirements
- All general requirements are fulfilled, see
- The unit is de-energized.
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
▪ Use a protective cover to protect the switch cabinet from chips.
▪ Provide the switch cabinet with cut-out (2) and holes (1).
▪ For the prescribed dimensions (3) cut-out radius (4), refer to the figure Exterior view of the switch cabinet cut-
out.
▪ Deburr the cut edges.
▪ Remove chips and assembly waste from the switch cabinet.
 Cut-out and holes have been created.
Operating manual PWS and PWI 6502 T 785408480 © Pfannenberg GmbH
Cut-out for PWS air/water heat exchangers
Pos
2
4
General assembly requirements
Figure 6 - Switch cabinet exterior view
Designation
Cut-out
Cut-out radius 20 mm
Page 12 / 31