Braun 5491 Mode D'emploi page 9

Keeping your shaver in top shape
Automated cleaning
The Braun Clean&Charge automatically takes care of all
cleaning and lubrication needs of your shaver. Please refer
to the separate use instructions.
If not supplied already with your shaver, the Braun
Clean&Charge is available at your dealer or Braun Service
Centers.
Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil
(do not remove the foil completely). Switch on the
shaver for approx. 5-10 seconds so that the shaved
stubbles can fall out.
For a thorough cleaning (weekly), remove the shaver
foil and tap it out on a flat surface. Using the brush,
clean the cutter block and the inner area of the pivoting
head. About every four weeks, clean the cutter block
with Braun cleaning agents.
If your skin is very dry and you notice a reduced operation
time of the shaver or if the display shows «oil!»,
apply a drop of light machine oil onto the shaver foil.
Do not rinse the shaver in or under water.
Replacing the shaving parts
The shaver foil and cutter block are precision parts that,
in time, are subject to wear. Replace your foil and cutter
block every 18 months and get a 25% better shave.*
(Shaver foil and cutter block: part No. 7000)
*(Overall evaluation from Braun users comparing their
shave with new parts and those used for 18 months.)
Accessories
available at your dealer or Braun Service Centers:
• Shaver foil and cutter block (part No. 7000)
• Refill cartridge (double pack) CCR 2 (#5331)
Syncro
7000
7000
9