IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be
followed, including the following:
• READ ALL INSTRUCTIONS BEFORE USE
• To protect against electrical hazards, do not immerse the cord, plug or motor base
in water or other liquids.
• Always use the product on a clean, flat, hard, dry surface. There should be no
material such as a tablecloth or plastic between the unit and surface.
• Avoid contacting the blades and any moving parts.
• Keep hands and utensils out of jar while blending to reduce the risk of injury or
damage to the blender. A scraper may be used but must be used only when the
blender is not running.
• Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions, or is dropped or damaged in any manner. Return appliance to
the nearest authorized service facility for examination, repair or electrical or
mechanical adjustment.
• The blender blades are sharp. Handle carefully.
• To reduce the risk of injury, never place cutter-assembly blades on base without jar
properly attached.
• Always put the lid on the jar before operating the blender.
• When blending hot liquids beware of steam. Remove the filler cap from the lid to
allow steam to escape.
• Do not use outdoors.
• Do not allow the cord to touch hot surfaces or hang over the edge of a table or
counter.
• Unplug the blender when it is not in use, before taking off or putting on parts, and
before cleaning. To disconnect, turn appliance off by pressing ON/Off button and
remove plug from outlet.
• Never leave the appliance unattended while it is running.
• Close supervision is necessary when any appliance is used by or near children.
• Do not blend boiling liquids in the blender.
• The use of attachments, including canning jars, not recommended by the
manufacturer may cause a risk of injury to persons.
SAVE THESE INSTRUCTIONS
T
P
i
his
roducT
s for
Note: The maximum rating marked on the product is based on the attachment
that draws the greatest load. Other attachments may draw less power.
h
u
o
ousehold
se
nly
E1
This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended
to fit into a polarized outlet only one way. If the plug does not
fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to modify the plug
in any way. If the plug fits loosely into the AC outlet or if the AC
outlet feels warm do not use that outlet.
Extension Cords
Use only extension cords having an electrical rating not less than the rating of the
appliance (labeled on the appliance). Do not use damaged extension cords. Examine
extension cord before using and replace if damaged. Do not abuse extension cord and
do not yank on any cord to disconnect. Keep cord away from heat and sharp edges. The
extension must be arranged so that it will not drape over the countertop or tabletop,
will not be within the reach of children, and will not be tripped over.
Power Cord Instructions:
Please follow the instructions below to ensure the safe use of the power cord.
•
Try to position the blender near the power source to reduce the hazards
associated with power cords (such as becoming entangled or tripping over a
long power cord).
•
Do not pull, twist or otherwise abuse the power cord.
•
Do not wrap the power cord around the main body of the blender during or
after use.
POLARIZED PLUG
E2