DR-HO'S neck pain pro Manuel D'instructions page 11

ELECTRODE PAD GUIDELINES
• Only use the original electrode
pads, gel and wires supplied by
the manufacturer because other
electrode pads and wires may not
be electrically compatible with your
device.
• The pads should only be used on
one person to avoid skin reactions
or cross-contamination.
• Always turn the device o before
removing or repositioning the elec-
trodes.
• Wash skin thoroughly and then dry
it before applying the electrodes.
• Apply the whole surface of the elec-
trode pads fi rmly to the skin.
• Do not use electrode pads that do
not stick properly to the skin, or
only partially stick to the skin.
CLEANING & MAINTENANCE
DR-HO'S Neck Pain Pro and Pain
Therapy device:
• Use a wet cloth or neutral cleanser
to wipe the surface.
• Do not use volatile liquids such as
alcohol, thinner or gasoline.
• Keep well away from moisture, high
temperatures, direct sunlight or
water droplets.
• Please do not disassemble, repair
or rebuild the device yourself
because this will invalidate the
warranty.
• Remove the batteries from the
device if it is not used for more than
3 months.
2021-04-20 DRHO Artwork Neck Pain pro Manual V05.indd 11 2021-04-20 DRHO Artwork Neck Pain pro Manual V05.indd 11
• If the skin looks red after treatment,
you should not treat that area until
the redness has disappeared.
• The electrode pads can be reused
30 to 50 times depending on your
skin type and other conditions.
Whenever you notice that the pads
are not sticking properly to your
skin, or if the gel pads feel dry, you
should dab the gels with a small
amount of water by hand or using
the spray bottle (do not wash them
with water directly). This will help
restore the adhesiveness and
conductivity of the electrode pads.
If moistening the pads fails to make
them sticky again, they may need to
be replaced.
Body and foot pads:
• Never stick two electrode pads
close to each other.
• Keep the electrode pads clean
and never expose them to high
temperature and direct sunshine.
• Keep the electrode pads at
temperatures of 5~40°C.
• Gently clean the electrode pads
with a moist cloth or use a brush to
remove dust.
• Do not clean the pads with hot
water or chemicals.
• Do not touch the gel of the pads
with your fi ngers, as this could
reduce their adhesiveness.
11
04-06-2021 17:18 04-06-2021 17:18