Makita DLM480 Manuel D'instructions page 13

The table below shows the relationship between the
number on the mower body and the approximate mow-
ing height.
Number
1
2
3
4
5
6
7
8
9
10
Hold the lower handle with one hand, and then move
the mowing height adjusting lever with the other hand.
2
Fig.25
► 1. Mowing height adjusting lever 2. Lower handle
NOTE: The mowing height figures should be used
just as a guideline. Depending on the conditions of
the lawn or the ground, the actual lawn height may
become slightly different from the set height.
NOTE: Try a test mowing of grass in a less conspicu-
ous place to get your desired height.
Grass level indicator
Grass level indicator shows the volume of mowed
grass. When the grass basket is not full, the indicator
floats while the blades are running.
Fig.26
► 1. Grass level indicator
Mowing height
20 mm (13/16")
26 mm (1")
32 mm (1-1/4")
40 mm (1-9/16")
49 mm (1-15/16")
59 mm (2-5/16")
70 mm (2-3/4")
81 mm (3-3/16")
92 mm (3-5/8")
100 mm (3-15/16")
1
1
13 ENGLISH
When the grass basket is almost full, the indicator does
not float while the blades are running. In this case, stop
the operation immediately and empty the basket.
Fig.27
► 1. Grass level indicator
NOTE: This indicator is a rough guide. Depending on
the conditions of inside of the basket, this indicator
may not work properly.
Adjusting the handle height
The handle height can be adjusted in two levels.
1. Hold the lower handle, and then turn the knob 90°
while pulling the knob on the lower handle to release
the locking pin. Perform the same procedure on the
other side.
Fig.28
► 1. Lower handle 2. Knob
NOTE: Supporting the handle makes it easier to
release the locking pin when pulling the knob.
1
1
2