Maintenance; Lubrication - Benchmark 38248 Manuel De L'utilisateur

MAINTENANCE

Maintenance Schedule
Your rototiller has been designed and produced by the industry's leading manufacturer of outdoor power equipment to provide you with
years of reliable operation. Keeping your tiller in top running condition will prolong its life, and help you obtain optimum performance.
Please read this maintenance schedule, and note the recommended care operating intervals to extend the life of your unit.
Maintenance Operation
Check belt tension
Change forward belt
Engine maintenance
Check oil level/change oil
Clean tine axle shaft

Lubrication

EM = See engine manual
1 = Change oil after the first three to five hours of use, then after every 50 hours or every season. Change oil
every 25 hours when operating under heavy load or in high temperatures.
SERVICING THE ROTOTILLER
The following information will help you make the necessary
checks and perform the procedures required to follow the normal
care recommendations made for your rototiller unit.
If you prefer, your local authorized dealer can make these checks
and perform the required procedures for you.
Important: Use only approved Benchmark® spare parts.
For additional information visit online at www.ardisam.com or call 800-345-6007 M-F 8-5 CST
149cc FRONT TINE ROTOTILLER / 149 cm
Page
17, EM
17, EM
PREVENT ACCIDENTAL STARTING.
ENGINE MUST BE TURNED OFF AND COOL, AND SPARK
PLUG WIRE MUST BE REMOVED AND SECURED FROM
SPARK PLUG BEFORE CHECKING AND ADJUSTING ENGINE
OR EQUIPMENT. ACCIDENTAL ENGINE START CAN CAUSE
SERIOUS INJURY.
Owner's Manual / Manuel de l'utilisateur
ROTOCULTEUR DENT AVANT
3
Before
Each Use
16 X
16
X
X
17 X
17
WARNING
Spark
Plug
Wire
38248 (5140-006)
50 hours or
Every Season
X
X
1
X
X
15