Benchmark 38248 Manuel De L'utilisateur page 11

FIGURE 3
Tine Shield
FIGURE 4
FIGURE 5
FIGURE 6
For additional information visit online at www.ardisam.com or call 800-345-6007 M-F 8-5 CST
149cc FRONT TINE ROTOTILLER / 149 cm
Hairpin
Washer
Lower Tail
Mount
Wheel
Engine Mount
Deck
Dirt
Shield
Narrow
Tine
Width
Wide Tine
Width
7. a. Assemble the upper handle bar assembly onto the lower
loop mount using four M8 bolts, four M8 flat washers
and four M8 locknuts. The handlebar as well as the bolt
should go on the outer side of the lower loop mount, while
the washer and nut should be placed on the inside. SEE
FIGURES 7 & 8
b. The upper two bolts can be assembled through one of three
hole positions depending on the user's preferred handle bar
height (low, middle, high). For the highest height, insert bolt
into the most forward hole. For the lowest height, insert bolt
into the most rear hole. SEE FIGURE 7
8. Insert depth regulator/drag stake through bottom opening in
lower tail mount and secure with lock pin. Assemble drag
stake handle onto drag stake using accompanying M6 Bolt
and Nut. SEE FIGURE 9
Upper Bolt
Lower Bolt
Lower Loop Mount
FIGURE 8
FIGURE 9
Owner's Manual / Manuel de l'utilisateur
ROTOCULTEUR DENT AVANT
3
38248 (5140-006)
High
Position
Medium
Position
Low
Position
FIGURE 7
Nylock
Nut
Lock
Pin
Drag Stake
11