Maintenance And Storage - Benchmark 38248 Manuel De L'utilisateur

WARNING
THE RIGHT AND LEFT SIDES
OF YOUR ROTOTILLER ARE
DETERMINED FROM THE
OPERATING POSITION AS
YOU FACE THE DIRECTION
OF FORWARD TRAVEL.
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU
MUST ADD ENGINE OIL BEFORE STARTING ENGINE.
WARNING
HOT GASES ARE A NORMAL BY-PRODUCT OF A
FUNCTIONING INTERNAL COMBUSTION ENGINE. FOLLOW
ALL SAFETY INSTRUCTIONS TO PREVENT BURNS AND
FIRES.
DO NOT ALTER/MODIFY ENGINE:
NEVER ALTER OR MODIFY THE ENGINE FROM THE FACTORY.
SERIOUS INJURY OR DEATH MAY OCCUR IF ENGINE IS
MODIFIED OR ALTERED.
WHEN WORKING ON OR REPLACING PARTS FOR THE
ENGINE OR PRODUCT, YOU MUST ALWAYS FLIP THE ON/
OFF SWITCH TO THE OFF POSITION.
6
149cc FRONT TINE ROTOTILLER / 149 cm
L R
For additional information visit online at www.ardisam.com or call 800-345-6007 M-F 8-5 CST
OPERATION
• Do not operate tiller under the influence of alcohol or drugs.
• Never operate tiller without guards, covers, and hoods in
place.
• Keep hands, feet, and clothing away from rotating parts. Keep
clear of tiller tines at all times.
• Tines rotate when tiller is engaged; tines rotate when the
drive safety control lever is pulled down. Releasing the drive
safety control lever to neutral stops the tines.
• Use extreme caution when operating on or crossing gravel
drives, walks, or roads. Stay alert for hidden hazards or
traffic.
• After striking a foreign object, stop the engine, remove the
wire from the spark plug, thoroughly inspect the tiller for
any damage, and repair the damage before restarting and
operating the tiller.
• If vegetation clogs the tines, stop the engine and disconnect
the spark plug wire before removing vegetation by hand.
• If the unit should start to vibrate abnormally, stop the engine
and check immediately for the cause. Vibration is generally a
warning of trouble.
• Do not run the engine indoors; exhaust fumes are deadly.
• Do not overload the machine capacity by attempting to till too
deep at too fast of a rate.
• Never operate the tiller without good visibility or light.
• Be careful when tilling in hard ground. The tines may catch in
the ground and propel the tiller forward. If this occurs, let go
of the handle bars and do not restrain the machine.
• Take all possible precautions when leaving the machine
unattended. Disengage control lever, stop the engine, wait for
all moving parts to stop, and make certain guards and shields
are in place.
• When leaving the operating position for any reason:
- Shut off the engine.
- Wait for all moving parts to stop.

MAINTENANCE AND STORAGE

• Keep machine, attachments and accessories in safe working
condition.
• Check shear bolts, engine mounting bolts and other bolts
at frequent intervals for proper tightness to be sure the
equipment is in safe working condition.
• To prevent accidental starting, always disconnect and secure
the spark plug wire from the spark plug before performing
tiller maintenance.
• Never run the engine indoors. Exhaust fumes are deadly.
• Always allow muffler to cool before filling the fuel tank.
• Never store equipment with gasoline in the tank inside a
closed building where fumes may reach an open flame or
spark. Allow the engine to cool before storing in any building.
• Always refer to the operator's guide instructions for important
details if the tiller is to be stored for an extended period.
Owner's Manual / Manuel de l'utilisateur
ROTOCULTEUR DENT AVANT
3
38248 (5140-006)