Velleman CAMIP5N Notice D'emploi page 17

• Check the Send Mail on alarm checkbox to send a mail when an alarm is detected. Make sure to fill out all
fields on the Mail Service Settings page (see above).
• Check the Upload Image on alarm checkbox to upload images to an FTP server when an alarm is
detected. Make sure to fill out all fields on the FTP Service Settings page (see above). When this option is
checked, you can also set the upload interval (in seconds).
• Check the Scheduler checkbox to open the day schedule. Click on the schedule to set the time during
which alarm service must be enabled. Horizontal axis = hours, divided per 15 minutes and vertical axis =
day of the week.
PTZ settings
Set PTZ speeds for the different directions.
Upgrade Device Firmware
Only use this option when problems with the current version are noticed. Do not upgrade if the camera works
fine.
Caution: when the upgrade process is interrupted or a wrong version is installed the camera might not work
anymore.
When clicking on Upgrade Device Firmware or Embedded Web UI (User Interface), a browser window is
opened. Locate and select the new firmware/web UI.
Backup & Restore settings
Use this option to create a backup or restore your system configuration.
To create a backup, click Submit and choose a location to store the backup file.
To restore a previously made backup, click Browse to locate the backup and click Submit to start restoring.
Restore Factory Settings
Selecting OK will clear the memory and reset the device to factory settings. All settings, e.g. user settings, mail
and FTP settings, alarm schedule... are lost.
Reboot Device
Select OK to reboot the camera.
Note: this will reset the system time. Refer to Date&Time settings.
V. 02 – 22/05/2012
CAMIP5N
17 ©Velleman nv