Velleman CAMIP5N Notice D'emploi page 16

FTP Service Settings
Note: these settings only take effect when the option Upload Image on Alarm is checked in the Alarm
Service Settings menu (see below).
• Fill out all FTP server data. The port is usually set to 21.
• Set the FTP mode to standard (PORT) or passive (PASV).
• When desired, check the Upload Image Now checkbox and set an upload interval (in seconds).
• Press Submit to store the data before performing an 'FTP test'. A successful test will display FTP test
succeeded. Possible error messages are:
Cannot connect to server.
o
Check FTP server address
Network error. Please try later.
o
Check network cabling and settings.
Server error.
o
Check the FTP server
Incorrect user or password.
o
Make sure to enter the right user name and password.
Cannot access the folder.
o
Make sure the folder exists and your FTP account is authorized.
Error in PASV mode.
o
Make sure the server supports PASV mode.
Error in PORT mode.
o
If the device is behind a NAT (Network Address Translation) device, PASV mode must be selected.
Cannot upload file.
o
Make sure your FTP account is authorized.
Alarm Service Settings
• Check the Motion Detect Armed checkbox to enable motion detection. This also allows mails to be sent
out (see Mail Service Settings) and image upload to an FTP server (see FTP Service Settings).
Note: when the camera is in auto tilt/auto pan mode (see For Operator layout), motion detection and
external alarm input are disabled!
• The motion detect sensibility can be set between 1 and 10, with 10 being most sensitive.
V. 02 – 22/05/2012
CAMIP5N
16 ©Velleman nv