Brill MS 326 B Manuel D'utilisation page 20

en
STORAGE
CAUTION!
Risk of fire and/or explosion!
Do not store the machine in the vicinity
of naked flames or heat sources.
Empty the fuel tank before long periods of
storage (over the winter).
Only empty the fuel tank outdoors.
Allow the engine to cool down before storage.
Steps
1. Empty the fuel tank.
2. Start the engine and let it idle until it stops.
3. Let the engine cool down.
4. Loosen the spark plug with a spark plug so-
cket.
5. Pour a teaspoon of 2-stroke oil into the com-
bustion chamber.
6. Pull the starter cord slowly several times to
distribute the oil in the interior of the engine.
7. Insert the spark plug again.
8. Thoroughly clean and service the device.
9. Store the device in a cool dry place.
TROUBLESHOOTING
PROBLEM
Engine does not start
Engine starts but does not con-
tinue to run
Engine starts but does not run
with full performance
Motor runs spasmodically
Excessive smoke
In the case of faults that are not listed in this table, or faults that you cannot rectify without
assistance, please contact our customer service department.
20
RECOMMISSIONING
1. Remove the spark plug.
2. Quickly pull the starter cord to remove leftover
3. Clean the spark plug and check the spark
4. Prepare the device for operation.
5. Fill the tank with the correct fuel/oil mixture.
DISPOSAL
POSSIBLE CAUSE
Incorrect starting procedure
Wrong lever position on the
choke
Dirty, incorrectly adjusted or
wrong spark plug
Fuel filter clogged
Wrong lever position on the
choke
Air filter clogged
Dirty, incorrectly adjusted or
wrong spark plug
Incorrect fuel mixture
CAUTION!
Fire hazard!
Do not store fuelled machine in buildings
where the petrol fumes might come into
contact with naked flames or sparks!
oil from the combustion chamber.
gap. Replace if necessary.
Do not dispose of old
equipment,batteries or accumulators
as householdwaste!
Product, packaging, and accessories
were made with recyclable materials, and
should be disposed of accordingly.
CORRECTION
Observe operating instructions
Set the lever to RUN
Clean, adjust or exchange the
spark plug
Exchange the filter
Set the lever to RUN
Clean or exchange the filter
Clean, adjust or exchange the
spark plug
Use the correct fuel mixture
Storage
MS 326 B