AVG NOIRE BSC46DB Manuel D'utilisation page 24

"LO" is shown on the display panel; the alarm and the malfunction indicator light go on at the
same time.
NOTES
If too many bottles are put in at once or the door has not been closed tightly, the unit will
display the "HI" signal on the display panel. This is normal. Please wait 5 minutes after closing
the door and "HI" will disappear.
It is normal that the cabinet shows "HI" or "LO" from time to time. If it occurs frequently or lasts
for a long time, you can restart the unit by unplugging it, then re-plugging after 5 minutes. If the
problem occurs again after restarting, please contact customer service.
Before reconnecting the power, wait 3 to 5 minutes. Otherwise you could damage your
appliance. If you attempt to start the appliance before the end of this time delay, the appliance
will not turn on.
If you turn on the appliance for the first time or after a restart, or after it has been out of
operation for a long time, there may be a temperature difference between the temperature
inside the appliance and that on the LED display. This is a normal event caused by the duration
of the activation period. Leave the appliance turned on for several hours and the temperatures
will stabilize during operation.
SHELVES
To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment. To remove the shelves out of the rail, pull each
shelf approximately 1/3 out of the rail compartment.
To remove the shelves out of the rail lift the whole shelf as shown in the Fig. A & Fig. B . Hold on
to both rails and push the shelf until the notch aligns with the metal nail on each side of the
shelf track, lift the shelf then pull the shelf out towards you. Note: Do not try to remove a
Tablet when it is filled.
24