Braun MultiQuick 7 MQ 727 Manuel D'instructions page 13

Use the «hc» baby food chopper (10) for
smaller quantities. Maximum operation
time for the «hc» baby food chopper:
30 seconds. Max. amounts 3.5 oz. / 100 g.
Immediately stop processing when motor
speed decreases and/or strong vibrations
occur.
Before Use
• Pre-cut foods into small pieces for
easier chopping.
• Remove any bones, tendons and gristle
from meat to help prevent damage to
the blades.
• Make sure the anti-slip rubber ring
(10d/11d) is attached to the bottom of
the chopper bowl.
Assembly and Operation
• Carefully remove the plastic cover from
the blade.
• The blade (10b/11b) is very sharp!
Always hold it by the upper plastic part
and handle it carefully.
• Place the blade on the center pin of the
chopper bowl (10c/11c). Press it down
and give it a turn so that it locks into place.
• Fill the chopper with food and put on
the lid (10a/11a).
• Align the chopper with the motor body
(4) and click together.
• To operate the chopper, switch on the
appliance. During processing, hold the
motor body with one hand and the
chopper bowl with the other.
• Always chop harder foods (e.g. parme-
san cheese) at full speed.
• When chopping is complete, unplug
and press the EasyClick release buttons
to detach the motor body.
• Lift the lid up. Carefully take out the
blade before pouring out the contents
of the bowl. To remove the blade,
slightly turn it then pull it off.
Caution
• Do not use the chopper attachment to
process extremely hard foods, such as
5722112644 _MQ 725-727-735-777 USCA_S6-36.indd 13 5722112644 _MQ 725-727-735-777 USCA_S6-36.indd 13
unshelled nuts, ice cubes, coffee
beans, grains, or hard spices e.g.
nutmeg. Processing these foods could
damage the blades.
• Never place the chopper bowl in the
microwave oven.
Food Processor Attachment
The food processor attachment (12) can
be used for:
• chopping;
• slicing, shredding, and making french
fries.
Chopping (E)
Using the blade (12h) you can chop meat,
hard cheese, onions, herbs, garlic, vege-
tables, bread, crackers, and nuts.
Refer to the Processing Guide E for maxi-
mum quantities, recommended times and
speeds.
Before Use
• Pre-cut foods into small pieces for eas-
ier chopping.
• Remove any bones, cartilage, tendons
and gristle from meat to help prevent
damage to the blades.
• Make sure the anti-slip rubber ring
(12g) is attached to the bottom of the
food processor bowl.
Assembly and Operation
• Carefully remove the plastic cover from
the blade.
• The blade (12h) is very sharp! Always
hold it by the upper plastic part and
handle it carefully.
• Place the blade on the center pin of the
bowl (12f). Press it down and give it a
turn so that it locks into place.
• Fill the bowl with food. Attach the lid (12a)
to the bowl with the interlock (12e) posi-
tioned to the right of the bowl handle.
• To lock the lid, turn it clockwise so that
the interlock engages with a click.
13
09.02.17 09:08 09.02.17 09:08