Brandt BT16524VE Manuel D'instruction page 23

fr -francais
5 - PROBLEMS
Incidents may arise when using your washing machine:
If the screen shows one of the following errors and an alarm beeps, before calling Customer Service:
check whether:
- The water tap is
open.
5.1
If any other anomaly than those shown above is displayed, contact the After-Sales Service indicating the
code to make it easier for them.
Any attempt by the user or a non-professional to repair the appliance could endanger the user's safety
and will terminate the appliance's warranty.
Here are a few points to check:
Problems:
The washing machine will not start:
The linen is not or not sufficiently spun:
A puddle of water forms on the floor:
Strong vibrations when spin drying:
The machine does not drain:
The lid does not open :
The drum is blocked :
The drum doors open very slowly (on
machines fitted with gently opening doors) :
At the end of the program the display is off:
check whether:
- The lid is not
closed correctly.
- The drump is block
5.2
- The appliance is not plugged in or there is a power cut.
- You haven't pressed the «Start/Pause» button
- You have programed a delayed start.
- See problems 5.1 and 5.2
- You have selected a program without spin drying or with
limited spin drying.
- The spin safety system has detected poor distribution of the
washing in the drum : unfold the linen and program another
spin cycle.
- Check the height of the curved drain part
First remove the plug from the socket and turn off the water supply.
- Check that the seals
tightened (Diagram 1.2).
- Check the curved part is positioned correctly
-- The washing machine has not been released correctly
(Diagram 1.1.3).
- The floor is not level (paragraph 1.4).
- You have programed «Full drum stop».
- The drain hose is bent or squashed (Diagram 1.3).
- See problem 5.3.
- The program has not yet finished.
- Wait until the temperature inside the machine drops.
If you have access, check that a small item of linen is not trap-
ped between the drum and the tank, by removing part
the bottom of the drum (Diagram 4.2).
- See problem 5.2.
- Your machine has not operated for a long time.
- It is located in too cold a position.
- Detergent residue (powder) is blocking the hinges.
- in all cases, everything returns to normal after the doors have
opened initially.
- In order to save energy the display automatically turns off after
5 minutes maximum after the end of your program. A simple
press of any button brings your display back into operation
23
check whether:
- The pump filter is
clogged ; clean the
filter (paragraph 4.3).
5.3
Causes / Remedies:
are fitted and the connectors are
G
.
2
H (Diagram 1.3).
(Diagram1.3).
H
A
from
EN