Brandt BT16524VE Manuel D'instruction page 17

fr -francais
1 - INSTALLATION
1.1 -
UnpacKing
The following instructions must be respected :
— Remove the chocks from the lid and flaps of the
drum and open and close the drum carefully.
— Lift the washing machine and remove the motor
B chock and base
A
— Remove the strip C
the holes D (Diagram 1.1.3).
— Remove the 3 hose support clips,
the stoppers in the 3 holes (very important)
(Diagram 1.1.4).
1.2 - connection to the Water sUpply
(Diagram 1.2)
Connect the feed pipe with its new washers to the
coupling on the rear of the washing machine and
to a tap with a threaded Ø 20x27 endpiece.
1.3 - draining (Diagram 1.3)
Position the drain hose, fitted with the curved part,
H ensuring that the instructions shown on the
fr -francais
2 - USE
recommendations:
— Before inserting the linen, sort it by colour, how
dirty it is and the type of textile. Empty all pockets,
close zips, removes hooks from curtains, place
Small items of underwear in a mesh bag.
— Remove any loose buttons, pins and clips.
— Knot belts, and ties for aprons, etc.
2.1 -
loading yoUr Washing
Operate the handle of the lid and open the drum by
pushing the button
A
Once the linen has been put in, ensure that
the drum has been closed properly. Ensure
that the edge of the button is visible.
(Diagram 1.1.2 to 1.1.4)
(Diagram 1.1.2).
and place the stoppers in
E
and place
(Diagram 2.1)
.
diagram are respected and especially that the
connection is not air-tight: air must pass freely
between the drain hose and the drain to avoid
used water from flowing back up the hose into the
machine and bad smells being caused.
1.4 - levelling the machine (Diagram 1.4)
The appliance must be installed on a horizontal
floor. If required, and if it is equipped with adjus-
table feet at the front of the appliance, stabilise
your washing machine so that it is level. If it is fitted
with retractable castors, it may be moved by pul-
F
ling the lever underneath the appliance completely
to the left.
1.5 - electrical connection (Diagram 1.1.1)
Ensure that the indications on the data plate of the
Appliance are respected.
1.6 - cleaning before Use
Once installed, your washing machine must be
cleaned by programming a cotton cycle at 90°C
with nothing inside and with half a dose of washing
powder.
2.2 - Washing prodUcts and additives
(Diagram 2.2)
The product drawer has 4 compartments :
prewash (powder),
softener, bleach.
cl
— Use detergents that are certified for domestic
washing machines.
— Do not use liquid detergents with the pre-wash
cycle and/or delayed start.
— Do not exceed the maximum level.
2.3 - conseqUences of Using the Wrong
amoUnt of detergent
Use the right amount of detergent based on the
type and load of laundry. Too much detergent
may prevent laundry from being properly rinsed,
leaving behind traces of the product. On the other
hand, not using enough detergent can mean that
the laundry will not be correctly washed.
17
wash (powder or liquid),
EN