Technical Data - Burda RELAX DARK IRC IP55 Notice D'utilisation Et D'entretien

P :
OWER CORD
• The use of an extension cord with this appliance is not
recommended.
• The power cord must not come into contact with
heated parts of the device!
• Children aged from 3 years and less than 8 years shall
not plug in, regulate and clean the appliance or perform
user maintenance.
• Never remove the plug from the socket by pulling on
the cord! Never move the device by pulling on the cord or
carry the device by the cord!
• Do not wind the cord around the device! Do not
operate the device with the cord wound up!
• Do not clamp the cord, or pull it over sharp edges!
• Do not run cord under carpeting, throw rugs or runners
etc. Arrange cord away from areas where it is likely to be
tripped over.
•Never use the appliance if the appliance or cord is
damaged. Risk of injury!
• The energy supply to the heater must always be properly
earthed.
• The appliance must not be located neither directly below,
nor in front of a socket-outlet.
• The heater must be installed so as to prevent that the
switches can be touched from those who are in the shower.
• If the appliance is not used for a long period, disconnect
it from the power supply.
I :
NSTALLATION
• The installation should always be carried out by a
qualified electrician or a competent person in accordance
with the current electrical standards for your country:
(ex. HD 384 CENELEC for Mainland Europe, IEC 60446 and
BS
7671 for the United Kingdom, IEC 60445(2010) &
ET101:2008 for Ireland and IEC 60364-7 1988
Internationally, AS/NZS 3000 for Australia) and
according to the UE 2015/1188 standards. Risk of
fire!
• Only commission the device after it has been fully
installed.
• This heater comes with a pair of stainless steel adjustable
angle mounting brackets. The adjustable angle enables the
heater to be installed on horizontal and inclined surfaces.
NOTE:
After switching on the appliance for the first time and
following extended periods on non-use, the appliance
may expel a slight odor for a short time. It will not
affect the use of the heater.
To exclude unpleasant burnt odor, it is recommended
to keep the heater clean preventing accumulation of
dust on it
I :
NSTALLATION
In case of direct connection to the supply line, a bipolar
switch or a bipolar circuit breaker with contact opening
distance of at least 3mm must be fitted upstream from the
supply line. Contact an authorized service technician if you
are unsure if you have a switch or a circuit breaker installed
on the premises.
Plug in the device in the socket of main power, the
heater starts heating.
Unplug the device from the socket or press the switch
or the circuit break to power off the device.
C :
LEANING
• First, disconnect the equipment from the power supply
system!
• After the appliance has cooled down, wipe off dust with a
damp soft rag.
• During operation, it is necessary to periodically (once a
year) check the electric cable contacts and terminal
connectors for good tightening.
• Make sure all parts are dry before using again.
• Do not use any abrasive or caustic cleaning agents!
• Never immerse the appliance in water! Danger to life!
A -S S :
FTER ALES ERVICE
• All repairs must be referred to authorised personnel!
Therefore, you should contact your specialized dealer or
the customer service.
• Important! Any tampering with the appliance will
invalidate the warranty.
• Repairs carried out improperly and by unqualified persons
may have serious consequences for the user!
T D :
ECHNICAL ATA
• Connection/fuse: 230/240 Volt (50/60 Hz) with 16 Amp
C (= slow-blowing fuse)
• Output: 2200 Watt = BRELD2200-3 und 2400 Watt =
BRELD2200-1
• Guaranteed service life: up to 5000 hours with average
use
• Type of protection: IP55
• Weight: 7.8 kg
• Casing: Corrosion-resistance anodized aluminium
• Cable: 1.90m 3-wire 1.5 mm², Schuko plug
M :
AINTENANCE
• To avoid risk of failures it is necessary to operate the unit
for a few hours every 6 months.
• If you have any question relevant your appliance, call the
local authorized distributor or the nearest Service Centre.
Every repairs should be carried on by an authorized Service
Centre and also ask always for original spare parts.
• Before cleaning, be sure the appliance is disconnected
from the power supply and allowed to cool. Never
immerse the appliance in water or any other liquid.
GB