Makita CL114FD Manuel D'instructions page 15

Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw
into.
Attach the wall mount for cordless cleaner to a hard
wooden wall, beam or column, where the wall mount
for cordless cleaner can be firmly secured. Always be
sure that the wall mount for cordless cleaner is securely
attached before hanging the cleaner.
► Fig.44: 1. Wall mount for cordless cleaner 2. Plug
Troubleshooting
Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
Dust case cover does not close
NOTICE:
Do not attempt to repair cleaner by yourself.
Disposing cleaner
A Li-ion battery is built in this cleaner. Always remove it
before disposing of the cleaner.
Removing built-in battery
CAUTION:
Do not touch the terminals with
any conductive material.
CAUTION:
Avoid storing battery unit in a
container with other metal objects such as nails,
coins, etc.
CAUTION:
Do not expose battery unit to
water or rain.
CAUTION:
Do not disassemble or alter bat-
tery unit.
CAUTION:
The cleaner must be disconnected
from the supply mains when removing the battery.
1.
To remove the rear cover, push it in the direction of
the arrow.
► Fig.45: 1. Rear cover
2. Slide the built-in battery halfway. Disconnect the
lead wires from the battery by slightly moving back the
battery while pressing the connector in the direction of
arrow as shown in the figure.
► Fig.46: 1. Connector 2. Lead wires
3. Then slide the battery unit out completely.
► Fig.47: 1. Battery unit
4. Put the removed battery unit in a carton box so
that it is not circuit-shorted.
mount violently or hang other appliances than the
cleaner.
NOTE: When you don't charge the cleaner, the plug
can be stored on the wall mount for cordless cleaner
as illustrated.
Area to be investigated
Is dust bag or paper filter full of dust ?
Is dust bag clogged ?
Is paper filter clogged ?
Is the battery cartridge discharged?
Is the battery cartridge discharged?
Is dust bag or paper filter set ?
Installing replacement battery
To install the replacement battery, follow the removal
procedure in reverse.
pletely stored inside the cleaner before putting
the rear cover back in the original position. Failure
to do this may damage the lead.
► Fig.48
After installing the battery (see "SPECIFICATIONS"),
charge the battery before use.
CYCLONE ATTACHMENT
Optional accessory
► Fig.49: 1. Release button 2. Hook 3. Straight pipe
About the cyclone attachment
Using the cleaner with the cyclone attachment installed
reduces the amount of dust that enters the dust bag,
which helps to prevent the suction force from weaken-
ing. In addition, cleaning after use is also simple.
15 ENGLISH
CAUTION:
Do not hang the cleaner to the wall
Empty dust bag or paper filter.
Dust down or wash the dust bag.
Replace paper filter.
Charge the battery cartridge.
Charge the battery cartridge.
Set dust bag or paper filter.
CAUTION:
Route the lead so that it is com-
4. Cyclone attachment 5. Suction inlet
Fixing method