PRESIDENT JIMMY III Manuel D'utilisation page 27

2) FREQUENCY BAND SELECTION (F)
(Configuration: EU ; PL ; d ; EC ; U ; In)
The frequency bands have to be chosen according to the country of use.
Don't use any other configuration. Some countries require a user's licence.
See table on page 43.
1. Switch on the unit by pressing and holding the F key (6). The letter corres-
ponding to the current configuration flashes.
2.
In order to change the configuration, use the / keys (4) on the unit.
3. When the configuration is selected, press the F key (6) during 1 second.
The letter corresponding to the configuration is continously displayed
and a confirmation beep sounds.
4. At this point, confirm your selection by switching the unit off and then
switching it on again.
See frequency bands on pages 38 to 40 / configuration table on
page 42.
D) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions
- Weight
- Accessories supplied
2) EMISSION
- Frequency allowance
- Carrier power
- Spurious emission
- Audio response
- Emitted power in the adj. channel : < 20 μW
- Microphone sensitivity
- Max. drain
- Modulated signal distortion
: 40
: AM / FM
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V
: 115 (W) x 130 (D) x 45 (H) mm
: 0.560 kg
: 1 microphone electret with
support, mounting cradle, screws and
fused power cord.
: ± 300 Hz
: 4 W
: < 4 nW (- 54 dBm)
: 300 Hz to 3 KHz
: 3.0 mV
: < 2 A (13.2 V)
: 2 %
3) RECEPTION
- Max. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Max. audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
E) TROUBLE SHOOTING
1) YOUR RADIO WILL NOT TRANSMIT OR YOUR TRANSMISSION
IS OF POOR QUALITY
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that the microphone is properly plugged in.
- You are using the same modulation mode as your correspondent.
- Check that the programmed configuration is the correct one (see table
page 42).
2) YOUR RADIO WILL NOT RECEIVE OR RECEPTION IS POOR
- Check that the squelch level is properly adjusted.
- Check that the volume (1) is set to a comfortable listening level.
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that you are using the same modulation mode as your correspond-
ent.
- Check that the programmed configuration is the correct one (see table
page 42).
Consult the VOLUME ACCESSORY menu page 27.
-
3) YOUR RADIO WILL NOT LIGHT UP
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
27
: 0.5 μV - 113 dBm (AM)
0.35 μV - 116 dBm (FM)
: 300 Hz to 3 kHz
: 60 dB
: 3 W
: min. 0.2 μV - 120 dBm
max. 1 mV - 47 dBm
: 60 dB
: 70 dB
: 180 ~ 500 mA max. (13.2 V)