Publicité
Les langues disponibles
Les langues disponibles
-
Change the switch to position REF (reading of the SWR level). The reading on
the Meter should be as near as possible to 1. If this is not the case, readjust
your antenna to obtain a reading as close as possible to 1. (A SWR reading
between 1 and 1.8 is acceptable).
-
It will be necessary to recalibrate the SWR meter after each adjustment of
the antenna.
WARNING: In order to avoid any losses and attenuations in cables used for
connection between the radio and its accessories, PRESIDENT recommends
to use a cable with a length inferior to 3 m.
Your transceiver is now ready for use.
B) HOW TO USE YOUR TRANSCEIVER
1) ON/OFF ~ VOLUME
Turn on
: turn VOL knob (1) clockwise. The radio emits a beep if the key
beep is activated (see § KEY BEEP page 26). The radio is "on".
Display briefly shows the frequency band (see § FREQUENCY BAND SELEC-
TION page 26).
Turn Off
: turn VOL knob (1) counterclockwise until radio emits click sound.
Your radio is "off".
Volume
Adjustment: rotate VOL knob (1) clockwise to
Turn the same knob counterclockwise to
2) ASC (Automatic Squelch Control) ~ SQUELCH
Suppresses
undesirable background noises when there is no communication.
Squelch does not affect neither sound nor transmission power, but allows a
considerable improvement in listening comfort.
a) ASC: AUTOMATIC SQUELCH CONTROL
Worldwide patent, a PRESIDENT exclusivity.
Turn the SQ knob (2) anti-clockwise into ASC position. ASC appears on
display. No repetitive manual adjustment and a permanent improvement
between the sensitivity and the listening comfort when ASC is active. This
function can be disconnected by turning the switch clockwise. In this case
the squelch adjustment becomes manual again. ASC disappears from
display.
b) MANUAL SQUELCH
Turn the SQ knob (2) clockwise to the exact point where all background
noise disappears. This adjustment should be done with precision as, if set
to maximum (fully clockwise), only the strongest signals will be received.
increase
the volume.
reduce
the sound level.
25
3) Display
It allows you to visualize all the functions:
The BARGRAPH displays the reception level and the transmitted power
level.
4) CHANNEL SELECTOR ~ SCAN
CHANNEL SELECTOR:
keys / on the unit
These keys allow you to move up or down the channels. A beep sound is
emitted each time the channel is changed if the key beep is activate (see
§ KEY BEEP page 26).
SCAN
Scans
channels.
1.
Press and hold the / keys simultaneously to activate SCAN mode.
2.
Repeat the same action to deactivate SCAN mode.
5) MODE ~ EMG ~ VOLUME ACCESSORY
MODE (AM/FM)
Press the MODE (5) key to
select
mode appears on display. Your modulation mode has to correspond to the
one of your correspondent.
-
Frequency Modulation / FM: for nearby communications on a flat open
field.
Amplitude Modulation / AM: communication on a field with relief and
-
obstacles at middle distance (the most used).
In U configuration only: a short press on the MODE key (5)
tween the ENG or CEPT frequency bands. "UK" is displayed when the ENG
frequency band is selected. "UK" disappears from display when the CEPT
frequency band is selected (see table on page 38).
the modulation mode: AM, FM. The selected
alternates
be-
Publicité
