Samsung WA40A3A Serie Mode D'emploi page 50

Troubleshooting
No Code
High LED
6
Flashes
Mid LED
7
Flashes
Low LED
8
Flashes
Hot & Warm
9
LEDs flash
Hot & Cool
10
LEDs flash
Hot & Cool
11
LEDs flash
Hot & Extra
12 High LEDs
flash
50 English
WA3000A_DC68-03850F-00_EN.indd 50 WA3000A_DC68-03850F-00_EN.indd 50
Your Washer has tried to fill but has not reached the proper
water level.
NOTE
When the High LED is flashing, the washer drains for 3 minutes.
During this time, the POWER button is inoperative.
• If the information code remains, contact a customer service
center.
A fault is detected in the water level sensor.
If the information code remains, contact a customer service
center.
Your washer is not draining. It can also mean that the unit
senses a small clog while draining.
• Do the following:
1. Turn off the unit and turn it on again.
2. Select only the Spin Only.
3. Press the START/PAUSE to drain the water. If it still does not
drain, contact a customer service center.
Unbalanced load prevented your Washer from spinning.
• Redistribute the load, and then press the START/PAUSE
button.
Motor not running properly.
• Restart the cycle by presssing the START/PAUSE button.
• If the information code remains, contact a customer service
center.
Mems sensor is not working properly.
• If the information code remains, contact a customer service
center.
Door lock is not working properly.
• Close the lid tightly and restart the cycle.
• If the information code remains, contact a customer service
center.
Meaning
2020-12-07 2020-12-07 4:21:06 4:21:06