Publicité
Les langues disponibles
Les langues disponibles
• A strain relief must be used. Do not loosen the nuts already installed on the terminal
block. Be sure they are tight. Use a
• Since january 1, 1996, The national electric code requires that new wiring (not existing)
utilize a 4-wire connection to this dryer.
STEP 4 Level the dryer
To ensure optimal performance, the dryer must be level.
A
DV3000A(SEM)_DC68-03784P-00_EN.indd 27
/
" (1 cm) deep well socket.
3
8
1. Gently slide the dryer into the desired
location.
2. Use a level (A) and check the levelness
A
of the dryer from side to side and front
to back.
3. If the dryer is not level, turn the
leveling feet (B) left or right to adjust
the height.
4. Once the dryer is level, make sure the
dryer stands firmly on the floor.
5. Plug in the dryer.
B
• To set the dryer to the same height
B
• Extend the leveling feet only as
NOTE
as your washer, turn the leveling
feet to the right until it fully retracts
(A). Then, turn the leveling feet to
the left to extend (B) until the dryer
and the washer are the same height.
much as necessary. Extending the
leveling feet more than necessary
can cause the dryer to vibrate.
English 27
2020-12-07
4:50:56
Publicité
